dust collectors and fume extractors
     
   
 
 
CSA - Changing Brushes
 
     
       
     
 
 
Instructions
 

DISCONNECT POWER PRIOR TO ACCESSING TOP LID OR MOTOR SECTION

 
  • Remove the 2 screws on the motor access door.
  • You will now see the the motor as well as the brushes installed.
  • Using a screwdriver, unscrew the 2 screws holding down each of 2 gold colored brush casings
  • Lift gold colored tab and lift/pull out each brush
  • Replace each brush onto turbine motor, screwing down the phillips screws over tab.
  • Close motor access door and install the 2 screws
 
SERVICE NOTE: Please note that your system is equipped with carbon brushes and they need to be replaced at a maximum of every 500 hours of operation. Periodic Inspection of motor brushes is essential. Brushes should be changed at no less than 1/4" of brush material remaining. Failure to do so may result in damaged motors that will not be covered under warranty.
 
go_back
 

   
     
 
   
© OP-Studio - Quatro Air Technologies 2008-2009 All Rights Reserved